1 Output: Continuous current 100A , short-time current 120A (not less than 10 seconds);
1.2 Power input: 2 - 6 LiPo or 5 - 18 NiMH / NiCd battery pack;

--1.3 BEC Output: 3A ;
--1.4 maximum speed: 2 -pole motors 210 000 turn / minute, 6 pole motors 70 000 turn / minute, 12 pole motor 35000 turn / minute;
1.5 Size: 78mm (length) * 55mm (W) * 15mm (H);
1.6 Weight: 120g (including heat sink) ;
-- 2 Product Features
-- 2.1 Electrical safety features: power, regardless of the throttle stick in any position will not immediately start the motor, to avoid injury;
2.2 Throttle Calibration: Throttle range to adapt to different remote control differences, improve throttle response linearity;
--2.3 Programmable Items:
- Brake Settings: brake enabled / brake disabled;
-- - Battery type: Li-xx (Li-ion battery) / Ni-xx (nickel-cadmium or nickel metal hydride);
- Low Voltage Protection Mode: lower power / off output;
- Low Voltage Protection Threshold: low / in / high;
-- - Start mode: normal / soft / super soft and start;
-- - Timing: low / in / high, default is medium into the corner;
-- - restore the factory defaults;
2.4 Full Protection Features:
- Undervoltage Protection: Set by the user through the process;
- Overvoltage Protection: input voltage exceeds the input range are not allowed to start, automatic protection, also issued a rapid " beeping " alarm sound;
- Overheat Protection: Built-in temperature detection circuit, MOS tube temperature is too high off automatically when the power transfer;
- remote control signal loss protection: remote control signal is lost a second after the power down, then have 2 seconds to turn off without remote control signal is output;
-- Technology characteristics
-- 3.1 power input uses a large volume of military low-impedance electrolytic capacitors, which greatly improved anti-jamming capability;
--3.2 control circuit and power management ( MOSFET ) were used to separate printed circuit board, power board to the total thickness of copper 0.7mm , low impedance, is highly resistant to high current capability;
--3.3 output MOSFET power transistor with a separate heat sink, heat dissipation area is large enough to effectively reduce the device temperature, high current ability to work to improve the system;
3.4 single-chip computer control;
3.5 to provide gold-plated motor connectors and heat shrink tubing DPM, easy to install (Note: This is optional equipment);