This product was developed for you to make controllers setting easier and to extend
the possibilities of controller settings too.
Prog-Card possibilities
- Brake on ¡V brake is active
- Brake off ¡V non active brake
- Timming low (soft timming) ¡V for 2, 4, 6 pole motors. This timming gives maximum
efficiency.
- Timming high (hard timming) ¡V strongly recommended for outrunners
- Throttle curve linear ¡V half throttle is equal to 60% of maximum RPM
- Throttle curve logarithm ¡Vhalf throttle is equal to 45% of power and 80% of maximum RPM
- ACCU NiXX ¡V power pack type NiCd or NiMH
- ACCU Li-XX ¡V power pack type Li-pol or Li-ion
- Cut off voltage high ¡V cut off is set to 0,9 V per cell for NiCd/NiMH
3,0 V per cell for Li-xx
- Cut off voltage low ¡V cut off is set to 0,7 V per cell for NiCd/NiMH
2,7 V per cell for Li-xx
- Cut off hard ¡V motor is fully off immediately after reaching cut off voltage
- Cut off slow down ¡V motor turns off slowly by power reduction
Using of Advance plus Prog-Card
- set all six jumpers to required positions
- plug JR connector (part of controller) to the position ¡§controller¡¨
- connect with the motor
- connect power accu
- 12A-30A ESC, -you will hear one beep after turning the switch to on position
- disconnect power accus
- disconnect Prog-Card
- plug JR connector to the receiver ¡V motor control channel