Back to List
¡@
Corona 2.4Ghz DSSS Futaba module replacement system.The Corona 2.4Ghz system replaces the standard Futaba module on most Futaba PPM systems equipped with an FM module.Spec. Size: 37mm*59mm*22mmVoltage : 4.8 V - 6VRange : more than 1500mOperating current : 30 MASensitivity : 100dbmLatency : 22ms Included.Futaba 2.4Ghz ModuleAntenna2.4Ghz Receiver*Please take note of the Rx and Tx versions. V1 and V2 are not compatible.
Corona 2.4Ghz DSSS Futaba module & Receiver system V2 Corona 2.4Ghz DSSS Futaba module replacement system. The Corona 2.4Ghz system replaces the standard Futaba module on most Futaba PPM systems equipped with an FM module 8 channel Receiver Corona 2.4GHz RF module & Receiver Thank you for purchasing our Corona 2.4Ghz RF transmitter module & receiver. In order to fully utilize the performance potential of this system, we suggest you first read the manual. Using the Corona 2.4GHz system 1. Our new Corona 2.4GHz transmitter module and receiver are designed to completely eliminate radio interference and glitches which have troubled model hobbyists for years. The software designed exclusively for the transmitting module and receiver instantly locates and assigns safe and protected channels. Other flyers in the area can not create interference that normally would corrupt transmitter signals. . Features of Corona 2.4GHz transmitting module and receiver The new lightweight, advanced technology unit has the following features: 1. Extended operating range 1.5 km range, which has been tested in a real flying environment. 2. A 5dbi gain transmitting antenna ensures the wave lengths are evenly distributed throughout the transmitting horizon ensuring the stable signal . 3.One-key user friendly setup mode. 4.Double receiver antennas guarantee the plane receives the signal regardless of the maneuver or attitude. 5.The unique receiver design makes the Corona module easy to install and ensures reliability. 6.Corona's advanced needle design ensures the lightest possible receiver Transmitting and receiving communication setup Installation of receivers As the wave length of 2.4GHz is shorter, its ability to go around obstacles is weaker than receivers whose frequency is below the 100MHz .Therefore, when you install the antenna, you must avoid objects with high conductivity such as; metal parts, servos, ESC¡¦s,battery, wires, and carbon fiber structures. If possible put the end of the antenna outside of the fuselage. Receiver and Transmitter Setup Instructions By following these steps you will ensure your transmitter and receiver are properly setup and ready to fly. 1. Turn the transmitter on and adjust your transmitter to PPM mood and then turn the transmitter off. 2. Press and hold the programming button on the transmitting module, then turn the transmitter on. The LED on Module will flash between red and yellow indicating the transmitter is ready to program. 3. Press and hold the button on the receiver and connect the receiver to the battery. The LED on the receiver will flash two times indicating the receiver and transmitter are communicating on the same frequency. Turn off the transmitter and receiver. 4. Turn the transmitter on, when the LED flashes yellow connect the receiver to the battery. The LED on the receiver will flash indicating the receiver is operating properly. After following these steps to program your transmitter and receiver both modules will continue to operate on the same frequency each time you use the modules. If there is a need to reprogram your modules (adding another receiver) please follow these steps. We hope you enjoy your new 2.4 Ghz receiver and transmitter modules. They have been designed and produced using the highest quality control measures available. This system is not compatible with version one
Shopping Cart
